11/30/99
Here is a view showing the front control arms in place for the
first time. The gold lower arm still needs a bracket location fabricated to complete
the lower 'A' going forward for the single strut that carries the ball joint.
In this view the wheel is at projected ride height.
In this view you can see a little more detail. The lower mount
can be seen. It is adjustable on 3/4" centers up and down and by 1" to
increase or decrease track.
In this view looking down more of the mounting location can be
seen. I fabricated the upper A-arm mount to be adjustable up and down by 3 inches.
This will allow the roll center to be adjusted between 0" - 9" as needed.
I still need to weld on a cover for this opening in the crossmember.
This is the tire/wheel in it's approximate ride height location
of 3" frame to ground. Vertical travel will be limited to + or - 3 inches.